Lantronix WiBox Driver
Lantronix WiBox Dual-Port Wireless Device Server - device server overview and full product specs on CNET. WiBox® dual-port Device Servers enable you to connect equipment to b/g wireless networks via serial or Ethernet, quickly and easily. By merging. Find great deals for Lantronix WiBox WBX Serial Db-9 to g Modem Dual Port. Shop with confidence on eBay!
|Supported systems:||Windows XP, Windows Vista, Windows 7, Windows 7 64 bit, Windows 8, Windows 8 64 bit, Windows 10, Windows 10 64 bit|
|Price:||Free* [*Free Regsitration Required]|
Lantronix WiBox Driver
Using a method called serial tunneling, the WiBox encapsulates Lantronix WiBox data into packets and transports it over By connecting two WiBox units via a network, virtual serial connections can be extended across your facility or around the world.
With virtual COM ports Lantronix WiBox to remote device servers on the network, you can replace direct serial connections. It even includes a built-in web server, which can be used for configuration or to display operating and troubleshooting information on the attached Lantronix WiBox to online support.
The DeviceInstaller configuration software that's included simplifies installation and setup. WiBox can be set up locally through Lantronix WiBox serial port, or remotely over a network using DeviceInstaller Telnet or a web browser.
Flash memory provides maintenance-free, non-volatile storage of web pages, and allows future system software upgrades. In modem emulation mode, WiBox is used to replace dial-up modems. The unit accepts modem AT commands on the serial port, then establishes a network connection to the end device, leveraging wireless mobility and bandwidth to Lantronix WiBox dedicated modems and Lantronix WiBox lines.
If you did not configure them at its initial setup, leave those fields blank at the Authentication Required dialog and just press OK. For use with the ImageWriter, most Lantronix WiBox not Lantronix WiBox its default parameters can be left as is. The only important ones to set are the ImageWriter's communication parameters, Lantronix WiBox are shown in the following screenshot: In case the screenshot does not appear: If you make changes, press OK before leaving each page.
To write configuration changes you must select Apply Settings. The WiBox will reboot.
Adding the printer to OS X: The default port number for Port 1 is and Port 2 is Verify your Add Printer dialog resembles the following, particularly the Address and Protocol. Lantronix WiBox case the above Lantronix WiBox does not appear: Any human-readable names are permitted.
If Lantronix WiBox printer is not added almost immediately, a communication problem exists. Device firmware updates can be downloaded from Lantronix's website and subsequently uploaded to the WiBox via TFTP from the command line. Refer to Lantronix WiBox instructions Chapter I have not attempted this.
Regarding Safari's inability to configure the WiBox, the following explanation is excerpted and paraphrased from Lantronix technical support: It supports WPA2 Enterprise.